Print Page | Contact Us | Report Abuse | Sign In | Register
News & Media: Staff Columns

Three tips to ensure your bulk tank measurements are accurate

Tuesday, August 1, 2017   (0 Comments)
Posted by: Elizabeth Kempel, member services representative
Share |

One of DBMMC’s main roles as a verification cooperative is to perform bulk tank calibrations to assure accurate milk weights for our members. It is one of the most important services we provide.

Whether you are installing a new tank during an expansion on your farm or upgrading your old tank for more capacity or due to age, there are several important factors to remember.

 

  1. Drainage, slope and grading are key. Make sure all rain water is flowing away from the structural base of the tank. Whether the support is a concrete slab, building foundation or simple concrete posts, water can quickly erode the stability of the support system and cause movement in the tank. This can lead to milk weight errors during farm pickup.
  2.  Install gutters where needed. Rooflines without proper gutter systems can increase the amount of water deposited at the base of the tank, which can lead to accelerated erosion of the area. This can decrease the stability of the foundation or support system and lead to errors. Also, water that cannot drain away from the tank foundation causes heaving issues in the winter from freezing and frost.
  3. Always contact your DBMMC member services representative to property calibrate your tank after installation.

Pictures below show a tank calibration performed in Central Wisconsin, where DBMMC properly calibrated a bulk tank and graded the slope around the tank to avoid future issues.

 

Existing slope under the tank was inconsistent and was hindering water from draining away from the supports.

 
   

Staff properly graded the area by leveling the existing dirt and gravel.

  Additional gravel was added to improve slope away from the concrete supports.

 

If you have questions or concerns about your current bulk tank measurements or if you are planning a new bulk tank installation or upgrade, please contact your member services representative.

 

Scott Munes: (920) 493-2697

Elizabeth Kempel: (608) 921-4520

Jill Uhe: (608) 772-2241

Abby Anderson: (715) 641-2237

Butch Meissner: (715) 937-1682


Proud member of...